Electronics Manufacturing and UV Instruments Support

Warning message

Mean Menu style requires jQuery library version 1.7 or higher, but you have opted to provide your own library. Please ensure you have the proper version of jQuery included. (note: this is not an error)

EIT Supplier Requirements

EIT’s requirements for approved Suppliers, also known as Quality Assurance Provisions (QAPs), are now posted online on our web site (www.eit.com).

All approved Suppliers should review these as well as the EIT Purchase Order for any additional Supplier specific QAPs not listed on our website.  

“EIT Quality Assurance Provisions” is the main document that lists EIT requirements. The document can be found as a .PDF file at either one of the following two places on our web site:

Manufacturing Support > EIT Supplier Requirements > Supplier Requirements (a .PDF document at the bottom of the page)

Or

Manufacturing Support > Quality & ITAR > Supplier Requirements (PDF document at the bottom of the page)

All suppliers should review sheet 9 of 9 in the EIT Quality Assurance Provisions document. There is a “dummy” EIT Purchase Order. It points out the areas of concern for each P.O.  The only thing that you, as a supplier, are required to meet are the series listed near the bottom of the P.O.  and any that might be directly printed on the Purchase Order.

For example: If you are a Printed Circuit Board supplier it would be stated on the P.O., where indicated,: “Vendor QAP Series: QAP 1XX” meaning that you would be responsible for all of the 100 series provisions.

There may be some requirements that do not apply based on the commodity you supply to EIT.  For example: QAP 108 is intended for anyone supplying a “moisture sensitive device” (MSD). If you supply a MSD you would need to comply to the Provision. If you do not supply a MSD then you need not comply to QAP 108.

Also, all suppliers are required to read and comply with the contents of the document entitled:

“Supplier Environmental Compliance Requirements”

Please note that Suppliers providing bare PCB’s to EIT must also comply with W0018 & W0041.

EIT, LLC appreciates our suppliers and will work with you to form a successful business relationship. 

If you have any questions please contact your EIT, LLC Buyer or EIT Quality Assurance (quality@eit.com